Flaky ESP8266 Behavior: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Flaky ESP8266 Behavior= It resets itself, it produces garbage output, it plain hangs, it does not behave as expected - what can you about it? My Arduino library uses three...") |
No edit summary |
||
| Line 1: | Line 1: | ||
[[Hardware Problems]] | |||
=Flaky ESP8266 Behavior= | =Flaky ESP8266 Behavior= | ||
It | The EP8266 is great: It gives your IoT device WLAN and IP connectivity for only a few bucks. | ||
On the other hand, the ESP8266 is quite a hand full: It creates power spikes that have negative impact on its own operation and possibly that of your circuit, it experiences out-of-the-blue resets that have to be dealt with, and it suffers hang-ups that can only be cured with a hardware reset or uttering "The IT Crowd" mantra ("have you tried turning it off and on again"; https://www.youtube.com/watch?v=nn2FB1P_Mn8). | |||
My Arduino library uses three levels of measures to straighten out the balking chip: | My Arduino library uses three levels of measures to straighten out the balking chip: | ||
| Line 9: | Line 13: | ||
* "Turn if off and on again", by connecting an Arduino digital port pin to a transistor that controls the ESP power supply. That requires a transistor and minor wiring. And another IO pin. | * "Turn if off and on again", by connecting an Arduino digital port pin to a transistor that controls the ESP power supply. That requires a transistor and minor wiring. And another IO pin. | ||
You can't do more without modifying the ESP8266 firmware. | You can't do more without modifying the ESP8266 firmware. Wait, you can: check out [[Sufficient_power-supply|Sufficient Power Supply]] regarding power spikes. | ||
[[Hardware Problems]] | |||
Revision as of 23:09, 14 June 2018
Flaky ESP8266 Behavior
The EP8266 is great: It gives your IoT device WLAN and IP connectivity for only a few bucks.
On the other hand, the ESP8266 is quite a hand full: It creates power spikes that have negative impact on its own operation and possibly that of your circuit, it experiences out-of-the-blue resets that have to be dealt with, and it suffers hang-ups that can only be cured with a hardware reset or uttering "The IT Crowd" mantra ("have you tried turning it off and on again"; https://www.youtube.com/watch?v=nn2FB1P_Mn8).
My Arduino library uses three levels of measures to straighten out the balking chip:
- Soft-reset, by issuing a "restart" command to the ESP
- Hard-reset, by connecting an Arduino digital port pin to the reset pin of the ESP. This just requires a piece of cable. And an IO pin.
- "Turn if off and on again", by connecting an Arduino digital port pin to a transistor that controls the ESP power supply. That requires a transistor and minor wiring. And another IO pin.
You can't do more without modifying the ESP8266 firmware. Wait, you can: check out Sufficient Power Supply regarding power spikes.